1. The spindle DC motor power is 12KW; speed range: 1000 - 9000rpm. The spindle is equipped with a two-way converter. Three different grinding wheels can be installed on the same flange of the grinding wheel main spindle.
2. The water-retaining cover is made of 8 mm Lexan plastic, which is convenient for loading and unloading the cutting tools and internal lighting.
3. The working head is equipped by ISO40 standard, a diameter of 20 hydraulic expanding shanks, can avoid grinding interference, hydraulic expansion chuck contains six high precision fixture. (Standard diameters 4mm,6mm,8mm,10mm,12mm, 16mm).
4. It contains a capacity of 50 liters of cooling oil tank, up to 15 L / min, and finally filtered to the 5-micron cooling
5. Electronic hand wheel precision has four kinds of 1mm, 0.1mm, 0.01mm, 0.001mm to choose. Accuracy 480 mm / min: 1 micron; Protection level standard: IEO IP X8
6. Heavy design, closed structure, good rigidity, high strength, good stability.
The operation method of Tool Grinder BT-100
1. First, determine the diameter of the tool grinder BT-100 milling cutter. If you want to grind the 8MM end mill, use the 8MM collet and lock the cutter to the 50D sleeve.
2. Set the angle, the milling cutter sleeve slightly swing 4 ° (the bottom angle of the milling cutter is between 2 ° ~ 6 °).
3. Start grinding the bottom surface. For example, tool grinder BT-100 milling cutter, align the milling cutter with the grinding wheel. Complete the tool setting step and then grind the bottom angle of the milling cutter, finish grinding one edge and then replace another cutting edge. Grind in order.
4. Grind the center of the milling cutter to the escape angle, and swing the sleeve to about 10°, and then grind the center escape angle of each milling cutter.
5. Grind the second clearance angle of the milling cutter in turn.
6. Grinding tool grinder BT-100 The side edge of the milling cutter, with the top end against the spiral groove of the milling cutter. Aiming at the grinding wheel, pushing the sleeve to grind the spiral side edge of the milling cutter.
